Features

• Modular build-up using 19 inches standard instrumentation, modules and devices, 100% reconfigurable, upgradeable and reusable into other platforms.
• Standardized fixtures with VPC 9025 (25 modules) mass interconnect interface Receiver. VPC Modules can handle signals up to 40 GHz
• Independent Industrial PC Controller with auxiliary UPS included, allowing automatic start at Power-On and a controlled Power-down even in case of Power Failure screen display.
• Advanced CAN bus Control for all 6tl modules including Operator Virtual Control Panels (Soft panels) allowing manual operation and test software debugging.
• Options for mounting NI PXI chassis
• YAV switching and special function modules, with minimal interconnection cabling need, providing optimal Signal Integrity. YAV Modules can manage signals up to 2,5 GHz.
• Test Fixtures Identification and automatic Test Executive Software Selection.
• Advenced Test Software based on NI Lab View®/Test Stand® and Phi6® Test Manager.
• Options for BAR Code and/or Data MAtrix Readers, Printer, platform status Beacon and RF screened fixtures.
• Teleservice by Ethernet fixed IP address.

Applications

• Electronic Boards Test
• LED Lighting Devices Test
• Assembled Electric Products Test

In-Line configuration with three 6tl-32 platform modules supporting up to six test stations and allowing a large number of different tests configurations in a high throughput production enviroment. This system is highly versatile with a quick test fixtures change over system, based on a VPC mass interconnect interface with 25 modules, allowing to setup multiple test station combinations and getting an optimal throughput performance when high volume production rates are required. Every 6tl-32 module can have a dual dwell fixture, providing a cost effective line-up solution to up to 6 stations, that can be balanced to perform all test phases required by the DUT.

Example 1: Using three identical dual dwell fixtures for a complette test of 20 sec, a production rate of 720 units per hour can be achieved, with the advantage that all the fixtures are identical.

Example 2: Using three dual dwell fixtures, where the first station will perform an in-circuit test, and sofware loading. The second station will perform a functional test.

Considering a total test cycle of 55 sec. per DUT (Software loading + Functional Test(, a production rate of 180 units per hour can be reached. Using only one station module (1 Fixture), the maximum production rate will be 60 units per hour.

General system specs:

L x W x H: 1532 x 1300 x 2086

Weight: 960 Kg

19 inch free mounting space: 48U

Power supply: 230 Vac 50 Hz /5A

Compressed air: 0,6 MPa

ESD safe design

SMEMA compatibility

CE approved

Transport specifications:

19 inch rack conveyor

Transport direction: L to R to R to L (to be specified on order)

Conveyor speed: 0,6 m/s

Conveyor Transport Height: 950 ± 25mm (SMEMA)

Automatic width adjustment from 50 mm to 384 mm

DUT specification for test in 6TL-32 system:

PCB max. Width: 390mm

PCB thikness > 0,4mm

PCBr (PCB ratio) [Length >= PCBr x width]: 0,8

PCB edge support width for conveyor transport: 4mm

Max. Component Height Top side: 80mm

Max. Component Height Bottom side: 6mm

Max. DUT weight: 2,5 Kg

Max. number of TPs (probing @2N): 600

Deflection of PCB: max. 0,4mm

Environment conditions

General Specifications

Ordering Information

Options

• CAN bus Indicator Beacon
• Data Matrix Reader and Lighting System

File Downloads

• 6tl-32 Datasheet